Now you’re an expert on vented and recirculating extractors and what the difference is.
What Is A Long Life Charcoal Cooker Hood Filter? Final Thoughts… Just wash the grease filters every now and then. If the cooker hood is installed using the vented extraction system, you do not need carbon filters.
#Extractor fan filters install#
You should always install carbon filters when your cooker hood is recirculating the air and not venting it outside.ĭepending on how much you use the extractor and your cooking style, these carbon filters should be replaced every 6-9 months. If you are having the cooker hood installed using the recirculating extraction system, then yes.
#Extractor fan filters how to#
How to clean grease filters Do You Need Carbon Filters For Your Cooker Hood? Simply unclip and remove them, then give them a soak and wash or even put them in the dishwasher (always check that they’re dishwasher safe first). Most grease filters are on simple clips on the underside of the cooker hood. Giving them a clean will never be a bad idea and it can be much easier than you think. If you barely use the hob and cooker hood, then you’ll probably be fine with 6-12 months. If you do a lot of cooking involving frying which releases more grease into the air, then maybe up that to 1-3 months. Obviously, this will depend somewhat on your style of cooking and how often you actually cook. How Often Do You Need To Clean Cooker Hood Grease Filters? However, If you are refurbishing an existing kitchen and you don’t already have any extraction to the outside of the room, then you do not need to have any installed. The extraction rate needed will depend on where it is situated in the room. If you’re having a new build or extension including the kitchen, then you must have some form of extraction (to outside). However, depending on the type of kitchen renovation project you are undertaking, you may have to have some form of extractor vented to the outside of your kitchen. There are recirculating kitchen extractor fans that will filter the air, taking out as much grease and smell as possible, then blow it back into the kitchen via a vent in the hood.
If the ducting isn’t sealed well or has to take turn after turn to wind its way to an outside wall, the effectiveness of the extractor starts to get compromised.Īlways try to take the most direct route to outside your house!ĭo You Need A Cooker Hood In A Kitchen? (UK) do kitchen extractor fans need to vent outside?
So all the grease and smells get thrown outside an away.ĭepending on what type of cooker hood/extraction unit you have and where it is located will determine if it’s possible to be vented out and if so, what the most effective route would be.įor example if you’re having a venting hob or downdraft extractor you may need to place the ducting in the floor.Īs a side note: Vented can lose its benefits if done poorly. This allows the air sucked up from your cooking to get completely removed from inside your house. With a typical wall-mounted cooker hood, this is usually a duct that comes up from the appliance and runs along the top of the wall cabinets to an exterior wall and then through the wall to the outside. You will then normally place a small grill in the brickwork of the external wall to allow the air that is sucked up by the extractor to then be expelled outside. Vented extraction is when you can connect a duct (or pipe) from the cooker hood and run this ducting through to an outside wall of your house. How To Buy The Best Cooker Hood For Your Kitchen What Is Vented Extraction?
0 kommentar(er)
